Installation Guide: Cutting Ring Fitting

• Fasten assembly cone in vice
• Apply lubrication on cone and cone threading before every preassembly.

Notice: periodically (after approx. every 50 usages) check assembly cone for wear and tear!

• Insert tube with cutting ring and swivel nut into the preassembly cone.
  Caution: push tube into the fitting all the way, otherwise the tube connection might leak!
• Tighten swivel nut by hand.
• For control of the according rotations of the nut: mark nut.

• Tighten swivel nut with spanner approx. 1 1/4 rotations.
• Caution: The tube itself may not be turned!
• Loosen swivel nut.

• After preassembly with preassembly cone: check tube end for correct ridge on the tube.

Please Note: The cutting ring can be turned but it cannot slide up and down the tube when it is correctly installed!